Deburring & Finishing Fixtures
Fixtures that hold parts for deburring, polishing and inspection without marking them.
Fixtures for the last operation, where parts are finished and the risk is marking rather than size. Contact faces are plastic or nylon, and the part is presented so the burr is reachable.
How we make it: Custom CNC parts service →
3–5 weeks
1 piece
ISO 9001:2015
Technical Specifications
| Parameter | Value | Unit |
|---|---|---|
| Contact faces | Non-marking | standard |
| Position repeatability | 0.2 | mm |
| Cycle time | Reduced vs hand holding | note |
| Material contact | Plastic / nylon | - |
| Wet use | Stainless option | - |
| Load | To 20 | kg |
Available Materials
- Aluminium 6061-T6
- Engineering plastics (contact faces)
- Stainless 304 (wet areas)
- Nylon / PU pads
Typical Applications
- Deburring stations
- Polishing holding
- Edge breaking
- Washdown handling
- Final inspection
Surface Finishes
- Anodised
- Plastic contact faces
- Non-marking pads
- Laser marked ID
Industries Served
- Medical
- Aerospace
- Consumer Electronics
- Industrial Equipment
- Automotive & EV
What drives the price of this part
Derived from the callouts on this page. Where a driver is not on the drawing, it is not on this list.
- Tolerance
- Position repeatability at 0.2 mm is the tightest callout this family carries. Tightening a callout is a process decision, not a machining decision: below the standard ±0.005 mm the work moves to grinding or jig boring, and the price moves with it.
- Material
- The first material listed, Aluminium 6061-T6, rates 9/10 on our machinability scale at 95 HB. On this shop's scale a harder alloy means slower passes and more tool changes, and that is cycle time the quote has to carry.
- Order size
- Minimum order is 1 piece, so on a first order setup and programming are spread over very few parts and they are most of the price. Repeat orders at the same quantity are cheaper without anything on the drawing changing.
See how cycle time is calculated in the machining time calculator and what else moves a price in the cost driver reference.
How these parts are inspected
Matched to the callouts above and the instruments actually on the floor.
- Coordinate measuring machine (Zeiss CONTURA G2, two machines, GR&R 8.4% on the critical feature)
- Dimensional report against the drawing, with a 100% check on critical features rather than a sample
- Certificate of conformance and the mill certificate with every shipment
- Bore gauges and an optical comparator for hole position and edge form
The full equipment list, with counts, is on the capability page; the inspection sequence is on quality and inspection.
Questions buyers ask
- Why fixture a deburring operation?
- Because by then the part is finished and any scratch is scrap. Holding it properly is cheaper than reworking the cosmetic surfaces it touches.
Related part families
Assembly Jigs & Fixtures
Fixtures that hold components in position during assembly, so the joint is square before it is fixed.
Soft Jaws & Chuck Jaws
Soft jaws machined to your part profile, for holding finished or odd-shaped work without marking.
Inspection Stands & Bench Fixtures
Stands that hold a part for CMM or manual inspection, at a repeatable orientation.