Hob · Shape · Grind
Gears & Drivetrain
Hobbed, shaped and ground spur, helical, bevel and worm gears to AGMA 8–12, with matched housings if needed.
Precision Spur Gears
AGMA 8–12 spur gears, hobbed and profile ground, from 12 mm to 800 mm pitch diameter.
View Details →Helical Gears
Helical gears to AGMA 9–12 with ground flanks, for quieter drives and higher tooth loads.
View Details →Bevel & Miter Gears
Straight and spiral bevel gears for right-angle drives, lapped in pairs to a matched contact pattern.
View Details →Worm Gears & Wheels
Worm shafts and bronze wheels cut to matched centre distance, for high-ratio right-angle drives.
View Details →Gear Racks
Ground and hardened gear racks in 500–3000 mm lengths, straight to 0.05 mm per metre.
View Details →Internal & Ring Gears
Internal gears shaped or ground in bores from 60–800 mm, for planetary and clutch drives.
View Details →Splined Shafts
Involute and straight-sided splines cut or rolled on shafts, checked at the pitch diameter.
View Details →Gear Housings
Machined gearbox housings with bored bearing seats, held to centre-distance ±0.02 mm.
View Details →Plastic Gears
POM, nylon and PEEK gears cut or moulded, running quiet and needing no lubrication.
View Details →Bronze Gears
Bronze gears for wear pairs against steel, run-in quickly and resist corrosion.
View Details →Sprockets
Chain sprockets to ANSI and ISO profiles, hardened teeth and keyed or tapered bores.
View Details →Gear Blanks
Turned and hardened gear blanks with the bore and faces finished, ready for cutting or grinding.
View Details →Stainless Steel Gears
304 and 17-4 PH gears for washdown and corrosive service, cut after heat treat where needed.
View Details →Cast Iron Gears
GG25 and GGG40 gears for large, slow drives, cast to shape and then cut.
View Details →Planetary Gear Sets
Sun, planet and ring gear sets cut as a matched group, with the carrier if needed.
View Details →Timing Gears
Timing and index gears with keyway or dowel location, marked for one-way assembly.
View Details →Differential Gears
Bevel pinions and side gears for differentials, lapped as sets and case hardened.
View Details →Face Gears
Face gears for right-angle drives where a bevel will not fit the envelope.
View Details →Hypoid Gears
Hypoid gear sets for offset right-angle drives, lapped and quiet under load.
View Details →Sector & Segment Gears
Partial gears cut as sectors where the drive only sweeps part of a circle.
View Details →Ratchet Gears & Pawls
Ratchet wheels and pawls cut or formed as a pair, with the tooth form matched to the load.
View Details →Crown Wheels & Pinions
Crown wheels cut as matched pinion pairs, for final drives and differentials.
View Details →Gear Couplings
Crowned tooth gear couplings that transmit torque while allowing misalignment.
View Details →Worm Shafts
Ground and hardened worm shafts cut to match a specific bronze wheel.
View Details →Matched Spur Gear Sets
Spur gear pairs cut together so the ratio is exact and the set runs quiet.
View Details →