Process Capability

Every Process, One Responsible Supplier

We run milling, turning, EDM and grinding in-house; heat treatment and plating go to audited partners we have worked with for over a decade. One P.O., one DFM review, one quality plan - not five suppliers pointing at each other.

3-Axis Milling

MILL-3

The workhorse. Vertical machining centres for prismatic parts, pockets, slots and hole patterns.

Table up to 1300×700mm · ±0.005mm

5-Axis Milling

MILL-5

DMG MORI DMU 80 for complex geometries - undercuts, turbine blades, one-setup precision.

DMU 80 · Ø800mm swing · ±0.005mm

CNC Turning

TURN-1

Bar and chuck work for shafts, bushings, flanges. Live tooling for mill-turn hybrids.

Ø0.5–300mm bar · ±0.005mm · Ra 0.4

Wire EDM

EDM-1

For hardened materials, fine slots and profiles that milling cannot reach.

±0.002mm · Ra 0.2 achievable

Where EDM is the right call →

Surface Grinding

GRND-1

Precision flatness and parallelism for mating surfaces, fixture plates and tooling.

Flatness 0.002mm/100mm

When grinding is forced by the tolerance →

Heat Treatment

HT-1

Subcontracted to audited partners with full process certificates - hardening, tempering, nitriding.

38–62 HRC typical range

What each treatment does →

Surface Finishing

Finished in-house or by certified partners, with batch certificates on request.

Which finish a surface actually needs, and which process reaches it →

Anodising (Type II/III)

Hard coat 20–50µm, MIL-A-8625 based. Colour options for prototypes.

Powder Coating

RAL colours, 60–120µm, salt spray tested to 500h on request.

Electroless Nickel

Uniform plating for corrosion resistance, 12–25µm.

Bead Blasting

Uniform matte finish, 0.8–1.6µm Ra after blasting.

Passivation

Stainless steel per ASTM A967. Free of charge on machined stainless.

Chromate Conversion

For aluminium, clear and yellow, MIL-DTL-5541 based.

Not sure which process fits your part?

Send the drawing. We will tell you honestly which route is cheaper - and which is over-engineered.

Send Your Drawing