Cable Trays & Trunking
Perforated and ladder-type cable trays with bends, tees and couplers.
Cable trays and the fittings that go with them, because a tray run is only as good as its bends. Couplers and splice plates are supplied with the run so the installer is not improvising.
3–5 weeks
10 pieces
ISO 9001:2015
Technical Specifications
| Parameter | Value | Unit |
|---|---|---|
| Thickness | 0.8–2.0 | mm |
| Width range | 50–600 | mm |
| Load span | To 3 m between supports | note |
| Bend radius | To your cable | - |
| Couplers | Supplied with the run | - |
| Fittings | Bends · tees · reducers | - |
Available Materials
- Galvanised steel DX51D
- Stainless 304
- Mild steel DC01
- Aluminium 5052
Typical Applications
- Machine wiring runs
- Plant room distribution
- Marine and offshore cable runs
- Food plant cable routing
- Data centre containment
Surface Finishes
- Hot-dip galvanising
- Zinc plating
- Powder coat
- Passivate
- As-supplied
Industries Served
- Industrial Equipment
- Energy & Oil & Gas
- Marine
- Water Treatment
- Telecom & 5G
What drives the price of this part
Derived from the callouts on this page. Where a driver is not on the drawing, it is not on this list.
- Part size
- Thickness at 0.8–2.0 mm decides which machine the part lands on and how many setups it needs. Size is the driver buyers most often leave out of a first enquiry, and it is the one that changes the quote fastest.
- Material
- The first material listed, Stainless Steel 304 / 304L, rates 4/10 on our machinability scale at 201 HB. On this shop's scale a harder alloy means slower passes and more tool changes, and that is cycle time the quote has to carry.
- Order size
- Minimum order is 10 pieces, so on a first order setup and programming are spread over very few parts and they are most of the price. Repeat orders at the same quantity are cheaper without anything on the drawing changing.
See how cycle time is calculated in the machining time calculator and what else moves a price in the cost driver reference.
How these parts are inspected
Matched to the callouts above and the instruments actually on the floor.
- Coordinate measuring machine (Zeiss CONTURA G2, two machines, GR&R 8.4% on the critical feature)
- Dimensional report against the drawing, with a 100% check on critical features rather than a sample
- Certificate of conformance and the mill certificate with every shipment
The full equipment list, with counts, is on the capability page; the inspection sequence is on quality and inspection.
Questions buyers ask
- Perforated or ladder tray?
- Ladder for heavy cable and long spans because it is stiffer for its weight; perforated where you want containment and some screening. Both need the support spacing from the load chart, not from habit.
Related part families
Electrical Panels & Back Plates
Mounting plates and panel doors punched for DIN rail, glands and cable entry.
Perforated & Mesh Panels
Perforated and woven mesh panels for ventilation, filtration and RF screening.
Stainless Steel Enclosures
316L and 304 enclosures for washdown and marine service, with welded seams and IP sealing.