Machine · Fit · Test
Assemblies & Kits
Machined, plated, inspected and packed as one kit - no vendor ping-pong when a tolerance stack-up is spread over six parts.
Assembled Sub-Assemblies
Machined, plated, inspected and kitted as one part number, with the tolerance stack-up owned in one place.
View Details →Hydraulic Manifolds
Machined manifolds with cross-drilled galleries, pressure tested to 350 bar before shipping.
View Details →Electromechanical Assemblies
Mechanical parts with connectors, harnesses and sensors fitted and function-tested before shipping.
View Details →Pump Assemblies
Machined and assembled pump bodies with matched clearances, tested for flow and leak before shipping.
View Details →Valve Assemblies
Machined valve bodies with lapped seats, assembled and bubble-tight tested at the working pressure.
View Details →Gearbox Assemblies
Housings, gears, bearings and seals built and run-in as one unit with backlash recorded.
View Details →Frame & Machine Kits
Cut, machined and kitted structural frames with hardware, ready to bolt together on site.
View Details →Actuator Assemblies
Screw, gear and linkage actuators built and stroke-tested as delivered units.
View Details →Spindle Assemblies
Belt and motor spindles built with matched bearings, runout measured at the nose.
View Details →Coupling Assemblies
Rigid, flexible and jaw couplings bored to fit your shafts, with keys and inserts fitted.
View Details →Linkage Assemblies
Rods, clevises and pivots assembled as one unit, with the pivot clearances set before shipping.
View Details →Machine Modules
Slide, index and lift modules built, aligned and function-tested before delivery.
View Details →Brake Assemblies
Machined brake discs, drums and caliper parts assembled and runout-checked as units.
View Details →Clutch Assemblies
Machined clutch plates, hubs and drums assembled with the engagement clearance set.
View Details →Filter Housings & Assemblies
Machined and fabricated filter housings, basket assemblies and screens, pressure tested.
View Details →Sensor Mounting Assemblies
Sensor brackets and mounting assemblies with the air gap or target distance set at build.
View Details →Drive Assemblies
Motor, coupling and reducer assemblies aligned and run-tested as one unit.
View Details →Hydraulic & Pneumatic Cylinders
Machined and honed cylinders assembled with seals fitted and function tested.
View Details →Heat Exchanger Assemblies
Shell and tube units with machined tube sheets, expanded tubes and pressure testing.
View Details →Enclosure Assemblies
Enclosures supplied complete with fans, filters, gland plates and earth studs fitted.
View Details →Conveyor Modules
Conveyor sections built complete with rollers, frames and drives, aligned and run.
View Details →Pump Cartridges
Cartridge assemblies of rotor, shaft and bearings, tested for clearance and leak.
View Details →Motor Assemblies
Frames, end caps and shaft assemblies built to take a standard motor stator.
View Details →Gear Motor Units
Gearbox and motor built as one unit, aligned, run-in and supplied with test data.
View Details →Test Rig Assemblies
Test rigs and fixture assemblies built to a test spec, instrumented and proven.
View Details →